Fujitsu M10 Product Notes

primary#

ldm

migrate

ldg1

root@target-name
Target

Password:
Domain

ldg1

is

using

features

of

the

system

firmware

that

are

not

supported

in

the

version

of

the

firmware

running

on

the

target

machine.
Domain

Migration

of

LDom

ldg1

failed.
Table 3-4
Version of the firmware that support live migration
Migrate to SPARC M10
Systems
(XCP 2230 or later)
SPARC M10
Systems
(XCP 2210 or later)
SPARC M10
Systems
(XCP 2092 or
earlier)
SPARC T-series
SPARC M-series
(*1)
(SysFW 8.4 or later)
SPARC T-series
SPARC M-series(*1)
(SysFW 8.3 or earlier)
Migrate from
SPARC M10
Systems
(XCP 2230 or later)
available available(*2) not available available not available
SPARC M10
Systems
(XCP 2210 or later)
available available not available available available
SPARC M10
Systems
(XCP 2092 or
earlier)
available available available available available
SPARC T-series
SPARC M-series
(*1)
(SysFW 8.4 or later)
available available not available available not available
SPARC T-series
SPARC M-series
(*1)
(SysFW 8.3 or
earlier)
available available available available available
*1 It is a system like SPARC M5/M6 which supports Oracle VM Server for SPARC.
*2 Live migration is possible only for cpu-arch=generic.
When performing live migration from a SPARC M10 system with XCP 2210 or
newer, to another SPARC M10 system, make sure to update the XCP firmware of
the target system to XCP 2210 or newer.
Refer to the following table for the feasibility of performing live migration based
on the version
of the firmware.
Notes on a case when recovery mode of Oracle
VM Server for SPARC is enabled
■
Suppose that a system disk in a physical partition (PPAR (PPAR #A)) in which
recovery mode is enabled is switched to a system disk that has been used for
another PPAR (PPAR #B). The PPAR #A domain configuration information held
in the XSCF may be overwritten on the PPAR #B domain configuration information.
If you want to use recovery mode to switch the system disk to the system disk that
has been used for another PPAR and boot from the new system disk, perform the
Chapter 3 Information on Software 37

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English