Fujitsu M10 Product Notes

PSU#1

cannot

be

replaced.
Table 3-6
Problems resolved in XCP 2240
SPARC M10-
RTINo. 1 4 4S Description Worka rou nd
RTIF2-
130305-003
xx xIf you reconnect the input power cable
soon after it is unplugged, the error log
of PSUs detect 100V and 200V at AC
inputs indicating that an error in the
configuration of the input power supply
may be registered.
- XCP 2041 or later
Wrong PSU is installed
- XCP 2032 or
earlier
PSUs detect 100V and 200V at AC inputs
There is no effective workaround.
Ignore this error log.
RTIF2-
140227-001
xWhen the cross-bar boxes are powered
on (AC ON) for the first time, the "SCF
panic detected" or the "XSCF hang up is
detected" error log may be registered
when XSCF is started.
There is no effective workaround.
[How to restore]
1. Confirm that all crossbar boxes and
SPARC M10-4S are displayed
with the
showhardconf(8) command.
2. Perform AC OFF/ON on all crossbar
boxes and SPARC M10-4S.
3. Check the master XSCF with the
showbbstatus(8) command. If
XBBOX#81 had been switched to
master XSCF, use the switchscf(8)
command to make XBBOX#80 the
master XSCF.
RTIF2-
140314-001
xIn case of a SPARC M10-1, to which XCP
2210 is applied, if an internal component
failure occurs in Type B motherboard
unit (MBU), it may not be detected and
the following error may be registered in
numbers.
- Voltage problem within MBU
FRU: /MBU
Msg: Critical low voltage error
Or,
- Fan speed
problem
FRU: /FAN#x, /MBU
Msg: FAN speed too low
There is no effective workaround.
[How to restore]
Replace the MBU.
To restore, after removing the replaced PSUs without the replacefru(8) command, use
the replacefru(8) command to replace the PSUs.
Problems resolved in XCP 2240
The following table lists the problems resolved in XCP 2240.
Chapter 3 Information on Software 83

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English