Fujitsu M10 Product Notes

Unused

4

0.0

backup

2

6.0

Use

the

whole

disk

Use

a

slice

on

the

disk
Esc-2_Continue

Esc-3_Back

Esc-6_Help

Esc-9_Quit
-------------------------------------------------------------------------
■
If an EFI (GPT) labeled disk is used, Oracle Solaris booting from a disk more than
2 TiB that is treated as a virtual disk is not supported.
■
If an EFI (GPT) labeled disk is used, any second GPT header is not supported on a
virtual disk.
Notes on Oracle VM Server for SPARC
■
If logical domains are reconfigured by Oracle VM Server for SPARC or if the guest
domain is reset with the XSCF firmware's reset(8) command after executing the
"ldm unbind-domain/ldm bind-domain" command and before executing the "ldm
add-spconfig" command, a guest domain other than what had been specified may
be reset. Or,
the specified guest domain is not reset. Save a configuration of the
logical domain with the ldm add-spconfig command. If you reset the guest
domain before saving it, execute the ldm stop command from the control domain,
not from XSCF.
■
If you specify a logical domain configuration for next time you start, use the ldm
set-config command in place of ldm add-spconfig -r.
If you use the ldm add-spconfig -r command to specify a logical domain
configuration for next time you start, and operate a guest domain with the reset(8)
command
of the XSCF firmware, another guest domain may be reset.
■
If you execute the ldm migrate-domain command with Oracle VM Server for
SPARC for live migration, the following problems occur with the XSCF.
- If you execute the showdomainstatus(8) command, "Unknown" is the status
displayed for the migrated guest domain.
If you execute the ldm add-spconfig command from the migrated control
domain to save configuration information, the status will be displayed normally
by the showdomainstatus(8) command.
- After live migration is executed, if showdomainstatus(8) is then executed at the
migration source, "Host stopped" is the status displayed for the migrated and
non-existent guest domain.
- When a physical partition (PPAR) is powered off
by the poweroff(8) command,
not all of the guest domains may be shut down correctly.
- When a guest domain is reset by the reset(8) command, a guest domain other
than the specified one may be reset. If you reset the guest domain, execute from
the guest domain, and not from
XSCF.
- If SNMP is set, the name of the guest domain in trap notification may be incorrect.
■
The migration with the ldm migrate-domain command is not supported if the
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240
･
March 201534

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English