Fujitsu M10 - Problems Resolved in XCP 2092

Table 3-12
Problems resolved in XCP 2210 (continued)
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
140605-005
xx xIf either of the following events occurs,
the ttydm process may fail, causing the
XSCF to be reset:
- The console(8) command is executed to
connect to the control domain console
after one of the following events
occurs: A large amount of data is
output to the screen of the domain
console and the console(8) command
terminates when the XSCFs for
multiple SPARC M10-4S chassis are
reset.
- The console(8) command is executed to
forcibly connect to the control domain
console.
If the ttydm process fails, the following
error log is registered:
[Example]
XSCF>
show logs error -v
Date: Dec 01 22:08:13 JST 2013
Code: 20000000-00fcff00b0000000ff-
010400010000000000000000
Status: Notice Occurred: Dec 01
22:08:04.886 JST 2013
FRU: /FIRMWARE,/XBBOX#80/XSCFU
Msg: SCF process down detected
Diagnostic Code:
00000000 00000000 0000
50000000 00000000 0000
00000000 00000000 0000
74747964 6d2e3239 37302e62 7a320000
00000000 00000000 0000
If the first five bytes on the fourth line in
[Diagnostic Code:] are "747479646d", the
ttydm process has failed.
There is no
effective workaround.
[How to restore]
- In the case of a system that consists of
multiple SPARC M10-4S chassis
By executing the console(8) command
after XSCF resetting, which causes
master/standby XSCF switching, you
can connect to the control domain
console.
- In the case of SPARC M10-1, SPARC
M10-4, or SPARC M10-4S
in a
single-chassis configuration
By executing the console(8) command
after XSCF resetting, you can connect to
the control domain console.
Problems resolved in XCP 2092
The following table lists the problems resolved in XCP 2092.
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240
･
March 2015114