Fujitsu M10 Product Notes

Table 3-13
Problems resolved in XCP 2092
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
131213-015
xIn case, all of the three conditions below
are met on a physical partition, the
crossbar unit (XBU) error "Msg: XB-XB
interface fatal error" is detected.
[Condition 1] The physical partition is
configured by several SPARC M10-4S.
[Condition 2] The XSCF BB control cables
that are connected to the SPARC M10-4S
chassis
are either defective or have been
disconnected.
In such a case, the "Msg: BB control cable
detected unexpected" error log is
registered.
[Condition 3] The physical partition was
rebooted due to a hardware failure, the
poweron(8) or reset(8) command was
executed.
Moreover, XSCF had either rebooted the
physical partition due to a
hardware
failure or had performed retrial of the
poweron(8) or the reset(8) command
when this symptom occurred previously.
There is no effective workaround.
Do not execute the poweron(8) or the
reset(8) command while the XSCF BB
control cable is disconnected.
[How to restore]
If hardware failure had occurred, execute
power off and
on, on the physical
partition.
If XSCF is performing retrial operations,
execute the "poweroff -f -p ppar-id"
command to forcibly power off the
physical partition. After that power it on.
RTIF2-
140110-001
xIn a SPARC M10-4S (with crossbar box)
configuration, the following event log,
which notifies power off, is not registered.
BB#xx was stopped by power failure.
Power failure date is yyyy/mm/dd
hh:mm:ss
There is no effective workaround.
RTIF2-
140110-002
xx xWhen the flashupdate(8) command is
executed, only occasionally, XSCF may
not start-up.
There is no effective workaround.
Contact a field engineer if this problem
occurs.
RTIF2-
140115-001
xx xIf a failure occurs in the PCI Expansion
Unit, all the domains that are situated in
the physical partition (PPAR) that is
connected to the PCI Expansion Unit, are
shut down.
There is no effective workaround.
Problems resolved in XCP 2091
The following table lists the problems resolved in XCP 2091.
Chapter 3 Information on Software 115

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English