Fujitsu M10 Product Notes

Table 7-1
Problems and their workarounds for all versions of the PCI expansion unit firmware
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
130703-001
xxWhen installing a PCI expansion unit by
PCI hot plug (PHP), among PCI
expansion unit slots 6, 7, 10 and 11, those
without HBA will have command
execution result "disconnected" instead of
"empty" for the Oracle Solaris cfgadm
(1M) command.
Although the display is not appropriate,
the slots work normally if you
mount
HBA.
This phenomenon does not occur if you
restart the logical domain after
connecting the PCI expansion unit.
This is just a display problem and does
not affect operation.
RTIF2-
130703-002
xxWhen you install a PCI expansion unit
with PCI hot plug (PHP), there may be
lane degrade.
When using PHP, execute cfgadm -c
configure instead of cfgadm -c connect.
RTIF2-
130703-003
xx When you install a PCI expansion unit by
PCI hot plug (PHP), a PCI-Express
correctable error may occur and cause
degradation of the PCI expansion unit at
the next reboot.
If there a fault error message is output
after installing a PCI expansion unit with
PHP, reinstalled the PCI expansion unit.
RTIF2-
130703-004
xxWhen you install a PCI expansion unit
with PCI hot plug (PHP), the PCI
expansion unit may not be recognized.
If the PCI expansion unit is not
recognized after installing it with PHP,
reinstall the PCI expansion unit.
Problems with PCI Expansion Units
and Workarounds
This section describes problems regarding the PCI expansion unit as well as the
workarounds for them for each version of the PCI expansion unit firmware.
Problems and their workarounds for all versions of
the PCI expansion unit firmware
The following table shows problems that might occur in any versions of Oracle
Solaris being supported and workarounds for them.
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240
･
March 2015188

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English