Fujitsu M10 - Chapter 2 XCP 2240-Related Information; Latest Information on XCP 2240

Note -
After the firmware update completes, power-off/power-on of the physical partition
may be required.
For details on firmware update, see "16.1 Updating the XCP Firmware" in the Fujitsu
M
10/SPARC M10 Systems System Operation and Administration Guide.
Chapter 2
XCP 2240-Related Information
This chapter provides XCP 2240-related information.
■
Latest Information on XCP 2240
■
Notes and Restrictions
■
XCP 2240 Problems and Workarounds
Latest Information on XCP 2240
This section describes major changes in XCP 2240.
This XCP version modifies XSCF firmware and CMU firmware.
■
If XSCF is an NTP client, the DNS round-robin applied to the NTP server can be
used. For details, see the setntp(8) command and the showntp(8) command in
Fujitsu M10/SPARC M10 Systems XSCF Reference Manual.
■
The maximum number of logical domain channels (LDC) which can be specified
per guest domain has been expanded from 768 to 1984.
For details on logical domain channels, see Oracle VM Server for SPARC Release
Notes of the version you are using.
■
Dynamic PCIe bus assignment provided with Oracle VM Server for SPARC 3.2 is
supported. For details, see "Dynamic PCIe Bus Assignment" in Oracle VM Server
for SPARC 3.2 Administration Guide and Oracle VM Server for SPARC 3.2 Release
Notes.
11