Fujitsu M10 Product Notes

Table 3-11
Problems resolved in XCP 2220 (continued)
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
140507-015
xxIf the showhardconf(8) command is
executed on a system configuration with
3 or more BBs or crossbar boxes, wrong
information may be output at the
FRU-Part-Number of the crossbar cable.
[Example]
In case of crossbar cable no. R0:
Error:
CBL#R0 Status:Normal;
+ FRU-Part-Number:@@@D00Q@;
Ver:0020h;
+ Type:Optic; Length: 2;
Correct
：
CBL#R0 Status:Normal;
+ FRU-Part-Number: ALLT03FQPE;
Ver:0020h;
+
Type:Optic; Length: 2;
There is no effective workaround.
There is no effect of this wrong display
on the system.
RTIF2-
140507-017
xx xIf XSCF is reset using the rebootxscf(8)
command, the XSCF may stop due to
XSCF failure.
There is no effective workaround.
[How to Restore]
Turn off/on the input power (AC
OFF/ON) of the system.
RTIF2-
140507-018
xx xWhen the system is in the initialized
state, XSCF may not start even after
turning on the input power.
There is no effective workaround.
[How to Restore]
Replace the CPU memory unit lower
(CMUL), the XSCF unit (XSCFU), or the
motherboard unit (MBU).
Chapter 3 Information on Software 103

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English