Fujitsu M10 Product Notes

Table 3-11
Problems resolved in XCP 2220 (continued)
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
140606-005
x Suppose that the testsb(8) command
running for system board (PSB) diagnosis
detects one of the errors listed below
during the period between power-off and
power-on of the SPARC M10 Systems
chassis or crossbar box chassis. In this
case, the command terminates, leaving
the power to the chassis on.
- The DC-DC
converter (DDC) in the
chassis is faulty.
Error log: Msg: Power-on failure
- The circuit that monitors cooling
components within the chassis is
abnormal.
Error log: Msg: LLC protection circuit
test error
- A crossbar cable is connected to the
crossbar unit (XBU) within the chassis
in an invalid combination.
Error log: Msg: XB CABLE configuration
error
You can determine the occurrence of this
phenomenon from the above error log
and the output of the showboards(8)
command. If this phenomenon has
occurred, the command outputs "y" for
[Pwr] and "Failed" for [Test].
[Example] If the power to the SPARC
M10-4S chassis is on and the system
board
diagnosis indicates an error
XSCF>
showboards -a
PSB PPAR-ID(LSB) Assignment Pwr
Conn Conf Test Fault
---- ------------ ----------- ---- ---- ---- -------
--------
00-0 00(00) Assigned y n
n Failed Faulted
There is no effective workaround.
Check the error log and perform
maintenance on the component.
RTIF2-
140804-001
xx xWhen the fan speed is switched due to a
change in the intake air temperature, an
error log indicating an abnormal fan
speed may be erroneously registered for
a fan that is not faulty.
There is no effective workaround.
[How to restore]
Execute the replacefru(8) command and
select the fan for which
the error log has
been registered.
Follow the replacement instructions on
the maintenance menu, without
replacing the fan.
Chapter 3 Information on Software 105

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English