Fujitsu M10 - Page 158

(Current)

:config1
(Next)

:config1
--------------------------------------------------------------
Index

:1
config_name

:factory-default
domains

:1
date_created:-
--------------------------------------------------------------
Index

:2
config_name

:config1
domains

:2
date_created:'20xx-yy-zz

hh:mm:ss'
primary#

ldm

set-variable

fix-php=true

ldom
primary#

ldm

remove-variable

fix-php

ldom
primary#

ldm

remove-spconfig

config1
primary#

ldm

add-spconfig

config1
2.
Set a dummy variable and then clear it for all logical domains.
Execute the following commands for all logical domains.
3.
Save the changed configuration in XSCF to replace the current configuration
information.
In this example, the name of the current configuration information is replaced
with config1.
4.
Restart all logical domains.
Restoration after erroneous detection of the "SCF Diagnosis
initialize RTC" error (RTIF2-131107-002)
[How to restore]
■
If phenomenon 1 occurs:
a. If the Oracle Solaris time has returned to January 1, 1970, execute the setdate(8)
command to set the XSCF time again. In this case, the XSCF is reset. After that,
power off and on the PPAR.
b. If the Oracle Solaris time is other than January
1, 1970, contact a field engineer.
In this case, do not execute the resetdateoffset(8) of setdate(8) command on the
XSCF.
c. If the PPAR power is off, power on the PPAR. After that, check the Oracle
Solaris time, and perform the above steps a. or b.
■
If phenomenon 2 occurs:
a. If the Oracle Solaris time has returned to January 1, 1970, it is necessary to
initialize the time difference between the XSCF time and Hypervisor on all of
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240
･
March 2015144