Fujitsu M10 Product Notes

Table 3-21
Problems resolved in versions prior to XCP 2050 (continued)
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
130507-001
xx xThere is a case where a RAID volume
cannot be recognized after a power
failure occurred while using the
hardware RAID function.
Please run the activate-volume command
at ok prompt to activate a hardware
RAID volume.
For the detailed procedure, see "12.2.8
Re-enabling hardware RAID volume" in
the Fujitsu M10/SPARC M10 Systems
System Operation and Administration Guide .
RTIF2-
130515-001
x x x While the system is operating, the
following events may occur:
1. The prtpicl command no longer
responds.
2. Display data (such as the XCP version)
of prtpicl -v and prtdiag -v is not
output as expected.
3. For /var/adm/messages, the warning
message, "PICL snmpplugin: cannot
fetch object value", is output.
4. XSCF CMDD
process shutdown
occurs and an XSCF is reset
repeatedly, such that it becomes
unusable. At this time, system
operation can be continued.
There is no effective workaround.
[How to restore]
- If event 1 occurs:
Recover with the following procedure.
1. End the prtdiag(1M) command with
[Ctrl] + [C].
2. Wait for
about 30 minutes, and allow
an SNMP timeout to occur in the
XSCF.
3. In the control domain, execute the
svcadm(1M)command to restart the
picl service.
- If event 2 occurs:
Execute the command again. If results
are displayed, the system can be
operated continuously. If the state
where results
are not displayed as
expected continues, check whether the
XSCF is operating.
- If the XSCF is operating, use the
rebootxscf(8) command to reset the
XSCF.
- If the XSCF is not operating, turn the
input power supply of the system off
and then back on (AC OFF/ON) to
recover.
-
If event 3 occurs:
The system can be operated
continuously because this is a
temporary warning message.
- If event 4. occurs:
Turn off the input power supply of the
system, and then back on (AC
OFF/ON) to recover.
RTIF2-
130516-005
xx xIf the showcodactivation(8) command is
executed while data is being restored
with the restoreconfig(8) or
restorecodactivation(8) command, it may
be impossible to display the execution
results. If this occurs, the
showcodactivation(8) command ends
with a "codd internal error".
The execution results can be displayed if
the showcodactivation(8) command is
executed after
the execution of the
restoreconfig(8) or restorecodactivation
(8) command is completed.
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240
･
March 2015158

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English