Fujitsu M10 - Page 39

XSCF>

setpparparam

-p

xx

-s

bootscript

"setenv

auto-boot?

false"
PPAR-ID

of

PPARs

that

will

be

affected:xx
OpenBoot

PROM

variable

bootscript

will

be

changed.
Continue?

[y|n]:
XSCF>

poweron

-p

xx
DomainIDs

to

power

on:

xx
Continue?

[y|n]

:
y
xx

:Powering

on
*Note*
This

command

only

issues

the

instructi on

to

power-on.
The

result

of

the

instruction

can

be

checked

by

the

"showlogs

power".
XSCF>
XSCF>

console

-p

0
:
omitted
{0}

ok
{0}

ok

boot

-s
#

date

xxxx
4.
Specify false for the OpenBoot PROM environment variable auto-boot?,
execute the setpparparam(8) command, and disable the autoboot function of
the control domain.
5.
Execute the poweron( 8) command to power on the target physical partitions.
6.
Execute the console(8) command to switch to the console of the control
domain.
7.
Execute the boot -s
command to start Oracle Solaris in single-user mode.
8.
Execute the date(1M) command of Oracle Solaris to display the control
domain time.
9.
Set the control domain time by executing the date(1M) command.
10.
Enter the escape command such as ".#" from the control domain console of
the physical partition, and return to XSCF
shell.
11.
Execute the show date(8) command to display the XSCF time to confirm that
the control domain time of the target physical partition is the same as the
clock time of XSCF.
12.
If necessary, specify true for OpenBoot PROM environment variable
auto-boot?, Execute the setpparparam(8) command, and enable the autoboot
Chapter 2 XCP 2240-Related Information 25