Fujitsu M10 Product Notes

Table 3-5
Problems that might occur with XCP 2240 and workarounds (continued)
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
131213-002
xWhile in the process of adding or
removing a system board (PSB) using the
addboard(8) or deleteboard(8) command
of the DR feature, if another physical
partition is rebooted due to hardware
failure or the poweroff(8)/poweron(8)/
reset(8) command is executed on it, the
executed addboard(8) or deleteboard(8)
command may detect timeout and
terminate abnormally.
Do not execute the poweroff(8)/poweron
(8)/reset(8) command while the
addboard(8) or deleteboard(8) command
is being executed.
There is no effective workaround if any
hardware failure occurs while executing
DR.
[How to restore]
Check the status of the system board
(PSB) using the showboards(8) command.
Execute the addboard(8) or deleteboard
(8) command after that.
RTIF2-
131213-003
xWhile executing the poweroff(8)/
poweron(8)/reset(8) command on a
physical partition, if the addboard(8) or
the deleteboard(8) command of the DR
feature is executed on another physical
partition to add or remove a system
board (PSB), the addboard(8) or
deleteboard(8) command may detect
timeout and terminate abnormally.
Do not execute the addboard(8) or
deleteboard(8) command while the
poweroff(8)/poweron(8)/reset(8)
command is being executed elsewhere.
There is no effective workaround if DR is
executed while also executing power
supply operations on another physical
partition.
[How to restore]
Execute the following:
1. Execute the showboards(8) command.
2. Check the status of /Pwr/Conn/Conf/
Test of the system board (PSB) to
confirm the end of power operations.
- End of power-on/reset:
The status of Pwr/Conn/Conf/Test is
"y y y passed" respectively.
- End of power-off:
The status of Pwr/Conn/Conf is "n n
n" respectively
3. Re-execute the addboard(8) or the
deleteboard(8) command.
RTIF2-
131213-010
xx x When the firmware of the PCI Expansion
Unit is updated with the "ioxadm –c
update" command, process down may
occur at the XSCF firmware.
There is not effective workaround.
Re-execute the "ioxadm –c update"
command to update the PCI Expansion
Unit firmware again.
Chapter 3 Information on Software 47

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English