Fujitsu M10 - Page 99

Table 3-6
Problems resolved in XCP 2240 (continued)
SPARC M10-
RTINo. 1 4 4S Description Worka rou nd
RTIF2-
140616-003
xx xIf microSD card in the XSCF or in the
XSCF unit is faulty, you may be unable to
access the data in the restored XSCF. In
this case, when you execute the
setservicetag(8) command, it will
abnormally terminate with the error
message "An internal error has occurred.
Please contact your system administrator."
There is no effective workaround.
[How to restore]
Replace the motherboard unit (MBU), the
CPU memory unit lower (CMUL), or the
XSCF unit (XSCFU).
RTIF2-
140710-001
x x x After you replace a motherboard or CPU
memory unit lower (CMUL), the XCP
firmware version should differ from the
pre-replacement version. Nevertheless,
the message "XCP version of XSCF and
Back-Panel mismatched!" that should
appear at the time of login to XSCF is not
displayed.
There is no effective workaround.
[How to restore]
When replacing a component, execute
the following procedure:
1. Before replacement, execute the
version(8) command to check the XCP
version.
[Example]
XSCF>
version -c xcp
BB#00-XSCF#0 (Master)
XCP0 (Current): 2051
XCP1 (Reserve): 2051
2. After replacement, execute the
version(8) command to check the XCP
version again.
3. If the XCP versions before and after
replacement
do not match, execute the
flashupdate(8) command to update the
firmware.
[Example] Updating to XCP 2052
XSCF>
flashupdate -c update -m xcp -s
2052
Chapter 3 Information on Software 85