BX900S2 Operating Manual 55
Hardware installation
Ê Fasten the holding-down clamp at the upper end of the support bracket
using two centering screws, see (1) in figure 6.
I For the symmetrical racks:
The support bracket is not necessary for the symmetrical rack.
Please position the holding-down clamp directly on the support
upright.
Ê Fasten the second holding-down clamp at the same height as the first one
to the rear right support upright using two centering screws.
Ê Identify the right and the left rail.
Figure 7: Attaching the left carrier rail
Ê Position the carrier rail in the support bracket (insert knob) - see (1).
I For the symmetrical racks:
The support bracket is not necessary for the symmetrical rack. There
is no support bracket. Please position the support system directly on
the support upright.
/
0
1
To Next Page
Loading...
