BX900S2 Operating Manual 59
Hardware installation
Figure 10: Installing the system unit
Ê Remove the front two handles (both sides) on the side of the system (1).
Ê Push the system unit into the rack as far as it will go.
Ê Fasten the system unit to the rack using the four knurled screws.
Ê Reinstall the server blades, storage blades, connection blades and
management blades, power supply units, fan modules and dummy modules
in their old bays, see page 57. Installation of these components is described
in the "PRIMERGY BX900 S2 System Unit Upgrade and Maintenance
Manual".
V CAUTION!
Incorrect fitting of the system unit may lead to serious errors.
Removing the system unit
V CAUTION!
● Make a note of the positions of the individual server blades, storage
blades, connection blades, power supply units and fan modules in the
system unit for reinstallation.
To remove the system unit, follow the installation instructions in reverse.
/
To Next Page
Loading...
