RX200 S6 Operating Manual 55
Hardware installation
Racks with installation depth smaller/greater than 735 mm
The support systems can be used for installation depths of 714 - 785 mm. The
spring element of the support system is used to adjust the length as required.
Ê Secure the support systems as described in section "Installing the support
systems" on page 51.
Ê Mount the server (see "Preparing the server" on page 52) and route the
cables as described in the original manual of the rack.
V CAUTION!
Ensure that the safety lock has been inserted before the server is
inserted (see figure 5 on page 51).
To Next Page
Loading...
