62 Operating Manual RX200 S6
Starting up and operation
Controls
On/Off button
When the system is switched off, it can be switched on again by
pressing the On/Off button.
When the system is operating, the result of pressing the On/Off
button depends on the operating system configuration (performing
a graceful shutdown, going into a sleep state/hibernation, do
nothing).
V CAUTION!
Risk of loss of data!
I The On/Off button does not disconnect the server from the
mains voltage. To disconnect from the mains completely,
remove the power plug(s).
NMI NMI button
V CAUTION!
Do not press! Risk of loss of data! The NMI button may only
be used by service.
RST Reset button
Pressing the reset button reboots the system.
V CAUTION!
Risk of loss of data!
ID ID button
ID LED lights up (blue) on the front and on the rear of the server
when the ID button is pressed. Both ID indicators are
synchronized.
To Next Page
Loading...
