48 Service Supplement RX300 S5
Replacing the system board Replacement routines
Figure 37: Positioning the system board and inserting the screw
Ê To position the system board use both center bolts (A and B).
Ê First attach the system board with the two screws (M3 x 6) in the orange
marked holes.
Ê Then fasten the system board with the other 8 screws (M3 x 6) (blue circles).
Ê Verify the settings on the new system board (refer to the Technical Manual
for a detailed description).
Ê Remove the Processor/s and memory modules from the old system board
and insert them in the new board (for more Informations see Options Guide
PRIMERGY RX300 S5).
Insert the processor cover in processor sockets of the old system board (for
more Informations see Options Guide PRIMERGY RX300 S5).
Ê Insert the PSU cage, fan box, fan box holder, processor heat sinks, and PCI
controllers (for more Information see Options Guide PRIMERGY RX300
S5).
Information about the cabling you will find in the “appendix“ of the Options
Guide.
B
A
To Next Page
Loading...
