Fujitsu PRIMERGY ServerView BX900 - Page 58

Control via Tabs Power Management
58 ServerView BX900 Management Blade
I To permit graceful shutdown of a server blade, ServerView agents must have been installed and must be
active.
Figure 48: Power Management – Power Switch tab (4/4)
In the Power Restore Policy column you can choose between the values Always Power Off, Always Power On and
Restore to Power State Prior to Power Loss for each server blade which was not added to the Server Blade Power-On/Off
Sequence.
I The Power Restore Policy is set to Always Power Off for all server blades which were not added to the Server
Blade Power-On/Off Sequence and cannot be changed.
A forced power-off can be enabled for each server blade in the fourth column in the table.
The time delay for a forced power-off after a normal power-off has failed can be set (in minutes) in the fifth column.
The table also provides information on other properties of the various server blades.