Fujitsu ScanPartner SP30F User Manual

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
107
How to Load
Documents
Scanner
Overview
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Troubleshooting
A shadow appears at the top or the bottom of the
scanned image.
Have you adjusted the offset (position to start the scan)?
No
In [Device Setting] of the Software Operation Panel, adjust the offset in the sub-
scanning direction.
For details, refer to "Adjusting the Position to Start the Scan [Offset/Vertical
magnification Adjustment]" (page 132).
Yes
Did you use the Page Edge Filler function to fill out the
shadow around the edge?
No
In the scanner driver or in [Device Setting 2] of the Software Operation Panel, use
the Page Edge Filler function to fill out the shadow around the edge.
For details, refer to "Removing Shadows/Streaks that Appear around the Scanned
Image [Page Edge Filler (ADF)]/[Page Edge Filler (FB)] (ScanPartner SP30F)"
(page 133).
Yes
If the problem persists, check the items in "7.4 Before You Contact the Scanner
Service Provider" (page 112) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.

Fujitsu ScanPartner SP30F Specifications

General

Brand	Fujitsu
Model	ScanPartner SP30F
Category	Scanner
Language	English