Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
99
How to Load
Documents
Scanner
Overview
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Troubleshooting
Images are distorted or not clear.
ADF:
Are the glass and rollers inside the ADF clean?
Flatbed (ScanPartner SP30F):
Is the document pad clean?
No
Clean the inside of the ADF.
For details, refer to "Chapter 5 Daily Care" (page 70).
Yes
Is the ADF being pushed down during scanning? Is there a
heavy object on top of the ADF?
Yes
Do not push down the top of the ADF, or place any heavy objects on the ADF
during scanning.
No
Is anything causing the scanner to vibrate during
scanning?
Yes
Do not allow the scanner to vibrate during scanning.
No
Is the scanner placed on a flat, level surface? Are the
rubber pads attached on the bottom of the scanner?
No
Either place the scanner on a flat and level surface, or attach the rubber pads on
the bottom of the scanner.
Yes
If the problem persists, check the items in "7.4 Before You Contact the Scanner
Service Provider" (page 112) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.
To Next Page
Loading...
Need help?
General