Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
24
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
This section explains how to power on/off the scanner.
How to Turn the Power ON
1 Press the [Power] button on the operator panel.
D The scanner is turned on, and during initialization, the Power
indicator flashes.
When the Power indicator turns on, the scanner is in ready status.
How to Turn the Power OFF
1 Press the [Power] button on the operator panel for more
than 2 seconds.
D The scanner is turned off, and the Power indicator turns off.
1.3 Turning the Power ON/OFF
HINT
You can select a method by which the scanner is powered on/off from
one of the following:
z Press the [Power] button on the operator panel
z Use an AC power strip that handles the power supply for peripherals
such as a scanner when the computer is powered on/off
z Have the scanner turn on/off in sync with the computer's power
For details, refer to "Method of Turning the Scanner ON/OFF [Power
SW Control]" (page 145).
HINT
When you press the [Power] button, the Check indicator will flash
once. Note that this is an initial diagnosis, and not a malfunction.
Check
Scan
/Stop
Power
To Next Page
Loading...
Need help?
General