Fujitsu ScanPartner SP30F User Manual

Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
125
How to Load
Documents
Scanner
Overview
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Operational
Settings
Item Description Parameter/Value Factory Default
Count
(page 129)
Check the counters to determine when to replace
the consumables.
Also use it to reset the counters after replacing
the consumables.
Total Count (ADF)/Total Count(FB) (ScanPartner SP30F) /
Brake Roller/Pick Roller
0
Power saving
(page 144)
Specify the waiting time before entering power
saving mode.
Range: 5 to 235 min. (in increments of 5) 15 min.
Power off after a certain period of time: Select to
set the scanner to turn the power off
automatically if the scanner is left on for a certain
period of time without being used.
Specify the timeout period for the scanner to be
automatically turned off.
[Power off after a certain period of time] check box Selected
1 Hour/2 Hours/4 Hours/8 Hours
(When the [Power off after a certain period of time] check box
is selected)
4 Hours
Offset Setting
(page 132)
Adjust the position to start the scan on the
selected scanning side(s).
Unit: Flatbed (ScanPartner SP30F)/ADF(front)/ADF(back)
Main/Sub: -2 to 2mm
(in increments of 0.5mm)
Main/Sub: 0 mm
Vertical
magnification
Adjustment
(page 132)
Adjust the magnification level in feed direction for
the selected scanning method.
Unit: Flatbed (ScanPartner SP30F)/ADF
Range: -3.1 to 3.1% (in increments of 0.1)
0%

Fujitsu ScanPartner SP30F Specifications

General

Brand	Fujitsu
Model	ScanPartner SP30F
Category	Scanner
Language	English