Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
33
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
This section explains about the basic flow of performing a
scan.
In order to perform a scan, you need a scanner driver and an
image scanning application that supports the scanner driver.
This product includes the following scanner drivers, and an
image scanning application.
z Scanner drivers
- PaperStream IP (TWAIN) for ScanPartner
- PaperStream IP (TWAIN x64) for ScanPartner
- PaperStream IP (ISIS) for ScanPartner
z Image scanning application
- Presto! PageManager
- ABBYY FineReader Sprint
Scanning procedures and operations will vary slightly
according to the image scanning application.
For details, refer to the manual of the image scanning
application.
The following describes the normal procedure for scanning.
1 Turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page 24).
2 Load a document in the ADF paper chute (feeder).
Load a document face-down in the ADF paper chute (feeder).
For details, refer to "Chapter 2 How to Load Documents" (page 38).
3 Start the image scanning application.
4 Select a scanner driver.
For some image scanning applications, it may not be necessary to
select a scanner driver.
5 In the scanner driver's setup dialog box, configure the
scan settings.
For some image scanning applications, the scanner driver's setup
dialog box may not appear.
1.9 Basic Flow of Scanning Operation
HINT
For details about the scanner drivers and image scanning application,
refer to "1.10 Bundled Software" (page 35).
To Next Page
Loading...
Need help?
General