Contents
Index
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
40
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
How to Load Documents
1 Pull out the chute extensions according to the length of
the document.
For details, refer to "1.6 Setting Up the ADF Paper Chute (feeder)"
(page 27).
2 Lift the stacker and stacker extension according to the
length of the document.
For details, refer to "1.7 Setting Up the Stacker" (page 28).
3 Load a document in the ADF paper chute (feeder).
Load a document face-down in the ADF paper chute (feeder).
4 Adjust the side guides to the width of the document.
Do not leave space between the side guides and the document.
Otherwise, the document may be fed skewed.
5 Scan the document with the image scanning application.
For details, refer to the manual of the image scanning application.
ATTENTION
Remove all paper clips and staples. Reduce the number of sheets
if a multifeed or pick error occurs.
To Next Page
Loading...
Need help?
General