Chapter 3 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
54
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Signals on the indicator
Check
indicator
Power
indicator
Description
Turns off Flashes Processing initialization.
Shown when resuming from power saving
mode or until the scanner is ready after the
ADF is closed.
Turns off Turns on Ready to start scanning.
Indicates that the initialization was
successfully completed.
This is referred to as "ready" status.
When the scanner is ready, the Check
indicator turns off and the Power indicator
turns on.
The indicators operate in the same way when
the scanner is in power saving mode.
Turns on Turns on Indicates that a temporary error occurred
during scanning.
The Check indicator turns on.
For details about errors, refer to "Temporary
Errors" (page 91).
The indicators return to the ready status if the
[Scan/Stop] button is pressed.
Flashes Turns on
or flashes
Indicates that a device error (alarm) occurred
during initialization or scanning.
The Power indicator turns on or flashes and
the Check indicator flashes.
For details about errors, refer to "Device
Errors" (page 92).
The indicators return to the ready status if the
[Scan/Stop] button is pressed.
If this alarm occurs, turn the power off and
then back on. If the problem persists after
turning the power back on, contact your
FUJITSU scanner dealer or an authorized
FUJITSU scanner service provider.
To Next Page
Loading...
Need help?
General