How to Configure Scan Settings
You can configure ScanSnap Manager scan settings in the ScanSnap setup window depending on
your intended use of the scanned images.
1. Click the ScanSnap Manager icon in the Dock while holding down the
[control] key on the keyboard, and select [Settings] from the ScanSnap
Manager menu.
a The ScanSnap setup window appears.
2. Configure the scan settings in each tab.
For details about each tab, refer to the ScanSnap Manager Help.
3. Click the [Apply] button.
a Scan settings are changed.
l When you use the Quick Menu, scan settings for the [Customize] button are changed.
l When you use a profile, scan settings for the currently selected profile are changed.
HINT
If you press the [Scan] button on the ScanSnap while the ScanSnap setup window is displayed,
the ScanSnap setup window closes and scanning starts. Scan settings that you have changed
are saved and documents are scanned by these settings.
Note that when other windows are open, these windows are not closed and scanning does not
start even if you press the [Scan] button on the ScanSnap.
How to Configure Scan Settings
83
To Next Page
Loading...
Need help?
General