ioxadm(8)
88 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised April 2010
OPTIONS The following options are supported.
-f Forces command execution by ignoring warnings.
-h Displays usage statement.
When used with other options or operands, an error occurs.
-M Displays text by page.
-p Displays only parsable output, suppressing headers in that output.
Fields are separated by single tabs.
-v Displays verbose output. Refer to specific operands for details.
target Specifies the target device, which can be a card mounted in a built-
in PCI slot in the host system; an External I/O Expansion Unit; or a
field replaceable unit (FRU) in an External I/O Expansion Unit.
The card in the host slot is identified by the host_path to the card.
host_path is platform dependent and indicates the path to the
slot on the host system that contains the card. The host_path has
the following format:
IOU#0-PCI#0 IO Board 0, PCI-E slot0
The External I/O Expansion Unit (box_id) is identified by serial
number.
Use iox@nnnn, where nnnn represents the last four digits of the
box serial number.
Some commands affect only a single component of an External
I/O Expansion Unit system. For example, individual boats and
power supplies can be turned on and turned off independently.
A FRU in an External I/O Expansion Unit (fru) is identified as:
iox@nnnn/iob0 – I/O boat in the left tray (rear view)
iox@nnnn/iob1 – I/O boat in the right tray (rear view)
iox@nnnn/iob0/link – Uplink card in boat 0
iox@nnnn/iob1/link – Uplink card in boat 1
iox@nnnn/ps0 – Power supply in the left bay (front view)
iox@nnnn/ps1 – Power supply in the right bay (front view)
To Next Page
Loading...
