showldapssl(8)
System Administration 415
NAME showldapssl - show LDAP/SSL configuration and messages
SYNOPSIS showldapssl
showldapssl cert [-v] [-i n]
showldapssl log [-M] [-C] [-S start_record_number] [-E end_record_number]
showldapssl log -f
showldapssl group administrator [-i n]
showldapssl group operator [-i n]
showldapssl group custom [-i n]
showldapssl userdomain [-i n]
showldapssl usermap
showldapssl defaultrole
showldapssl server [-i n]
showldapssl -h
DESCRIPTION showldapssl(8) displays the LDAP/SSL configuration and diagnostic messages.
Privileges You must have useradm privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
-f Displays diagnostic messages in real time. When this option is
used, the command does not terminate. Each diagnostic message
is displayed when it is registered. To stop the real-time display,
press Ctrl-C.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-i n Sets an index marker, value 1 - 5. When executed without -i, or
with -i and no value, showldapssl walks sequentially
through items 1 through 5. Exceptions: When used without -i,
the command showldapssl cert displays the certificate
information for the Primary server, and showldapssl server
displays the Primary server configuration.
-v Specifies verbose output. Used only with the cert operand to
display the full certificate.
To Next Page
Loading...
