showpacketfilters(8)
System Administration 459
NAME showpacketfilters - show the IP packet filtering rules that are set in the XSCF
network
SYNOPSIS showpacketfilters {-a | -l} [-M]
showpacketfilters -h
DESCRIPTION showpacketfilters(8) command shows the IP packet filtering rules that are set
in the XSCF network.
Privileges No privileges are required to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
EXTENDED
DESCRIPTION
The setpacketfilters(8) command can be used to set the IP filtering rules.
EXAMPLES EXAMPLE 1 On M8000/M9000 servers, shows the IP packet filtering rules that are set in
the XSCF network.
EXAMPLE 2 On M8000/M9000 servers, shows the operation status of the IP packet filter-
-a Shows the IP packet filtering rules that are set in XSCF.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-l Shows the operation status of the IP packet filtering rules that
are set in XSCF.
-M Displays text by page.
XSCF> showpacketfilters -a
-s 172.16.0.0/255.255.0.0 -i xscf#0-lan#0 -j DROP
-s 172.16.0.0/255.255.0.0 -i xscf#1-lan#0 -j DROP
-s 10.10.10.10/255.255.255.255 -j DROP
-s 192.168.100.0/255.255.255.0 -i xscf#0-lan#1 -j ACCEPT
-s 192.168.100.0/255.255.255.0 -i xscf#1-lan#1 -j ACCEPT
-i xscf#0-lan#1 -j DROP
-i xscf#1-lan#1 -j DROP
To Next Page
Loading...
