setsnmpvacm(8)
System Administration 289
NAME setsnmpvacm - modify the SNMPv3 agent’s View-based Access Control Model
(VACM) configuration
SYNOPSIS setsnmpvacm creategroup -u username groupname
setsnmpvacm deletegroup -u username groupname
setsnmpvacm createview -s OID_subtree [-e] [-m OID_Mask] viewname
setsnmpvacm deleteview -s OID_subtree viewname
setsnmpvacm createaccess -r read_viewname groupname
setsnmpvacm deleteaccess groupname
setsnmpvacm -h
DESCRIPTION setsnmpvacm(8) modifies the SNMP Agent’s VACM configuration. Using this
command requires a basic knowledge of SNMP.
Privileges You must have platadm privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
-h Displays usage statement.
When used with other options or operands, an error
occurs.
To Next Page
Loading...
