setsnmpvacm(8)
290 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised January 2007
OPERANDS The following operands are supported:
EXAMPLES
EXAMPLE 1 Create a Group
createaccess Sets access to a MIB view for the specified group.
-r read_viewname Specifies an SNMP Agent view.
groupname Specifies a valid group name.
creategroup Sets up a group for the specified user for view access.
-u username Specifies a valid user name.
groupname Specifies a valid group name.
createview Sets up a view of the SNMP Agent exported MIB information.
View access is limited to read-only for this Agent. The view is
identified through a MIB OID subtree and can be limited to
specific portions of that subtree using the OID Mask.
-e Specifies an excluded view. The default is an
included view.
-m OID_Mask Specifies a valid OID subtree mask. By
default, the mask is ff (entire subtree).
-s OID_subtree Specifies a MIB OID subtree. Values start at
.1 for the entire MIB tree.
viewname Specifies a valid view name.
deleteaccess Removes access entry.
groupname Specifies a valid group name.
deletegroup Removes a group from use.
-u username Specifies a valid user name.
groupname Specifies a valid group name.
deleteview Removes this view from use.
-s OID_subtree Specifies a MIB OID subtree. Values start at
.1 for the entire MIB tree.
viewname Specifies a valid view name.
XSCF> setsnmpvacm creategroup -u jsmith admin
To Next Page
Loading...
