ioxadm(8)
System Administration 87
NAME ioxadm - manage External I/O Expansion Units and add-in cards that contain
Energy Storage Modules and are attached to the host system
SYNOPSIS ioxadm [-f] [-p] [-v] [-M] env [-e] [-l] [-t] [ target [ sensors]]
ioxadm [-f] [-p] [-v] [-M] lifetime [ target | -z target]
ioxadm [-f] [-p] [-v] [-M] list [ target]
ioxadm [-f] [-p] [-v] [-M] locator [on|off] [ target]
ioxadm [-f] [-p] [-v] [-M] poweroff target
ioxadm [-f] [-p] [-v] [-M] poweron target
ioxadm [-f] [-p] [-v] [-M] reset target
ioxadm [-f] [
-p] [-v] [-M] setled [ on|off|slow|fast] target led_type
ioxadm -h
DESCRIPTION ioxadm(8) manages External I/O Expansion Units, link cards, and cards that
contain Energy Storage Modules (ESM) and are attached to the host system.
The M3000 server does not support External I/O Expansion Units.
When using this utility you must specify an operand, and any options that operand
requires. The target device can be a card mounted in a built-in PCI slot in the host
system; an External I/O Expansion Unit; or a field replaceable unit (FRU) in an
External I/O Expansion Unit. The card in the host system is identified by a string
that specifies the host path to the card. A linkcard installed in the host system is
called a downlink. A linkcard installed in an I/O Expansion Unit boat is called an
uplink.
For more information, see target in OPTIONS.
Privileges You must have one of the following privileges to run these commands:
Refer to setprivileges(8) for more information.
Required Privileges Operands
platop env, list
platadm env, list, locator, poweroff, poweron
fieldeng All operands
To Next Page
Loading...
