moveboard(8)
100 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised August 2009
OPTIONS The following options are supported:
-c assign Disconnects a configured XSB from its domain configuration and
assigns it to the domain configuration of the move destination. If
the -c option is omitted, "-c configure" is used.
-c configure Disconnects a configured XSB from its domain configuration and
configures it in the domain configuration of the move
destination. If the -c option is omitted, "-c configure" is used.
-c reserve Reserves disconnection of an XSB from its current domain
configuration, and reserves assignment of the XSB to the domain
configuration of the move destination. If the -c option is omitted,
"-c configure" is used.
-d domain_id Specifies the ID of the destination domain in which an XSB is to
be moved. domain_id can be 0–23 depending on the system
configuration.
-f Forcibly detaches the specified XSB.
Caution – If the -f option is used to forcibly remove the XSB
from the source domain, a serious problem may occur in a
process bound to CPU or process accessing a device. For this
reason, use of the -f option is not recommended in normal
operation. If the -f option must be specified, verify the statuses
of the source domain and job processes.
Note – The XSB which failed or detected the failure will not be
configured to the DCL forcibly.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-n Automatically answers "n" (no) to all prompts.
-q Suppresses all messages to stdout, including prompts.
-v Specifies verbose output. If this option is specified with the -q
option, the -v option is ignored.
-y Automatically answers "y" (yes) to all prompts.
To Next Page
Loading...
