setcod(8)
System Administration 173
After this command completes, you will see a message similar to this one in the
XSCF console:
EXAMPLE 2 Set the COD Headroom CPUs to 0
EXIT STATUS The following exit values are returned:
SEE ALSO SPARC Enterprise M4000/M5000/M8000/M9000 Servers Capacity on Demand (COD)
User’s Guide
PROC Permits reserved for domain 13 (0 MAX) [0]:
PROC Permits reserved for domain 14 (0 MAX) [0]:
PROC Permits reserved for domain 15 (0 MAX) [0]:
Aug 28 17:28:30 FF1-1-0 codd[PID]: COD PROC Headroom changed to 3
XSCF>
setcod 0
0 Successful completion.
>0 An error occurred.
To Next Page
Loading...
