setdualpowerfeed(8)
202 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised November 2009
EXAMPLE 2 Enables dual power feed mode in the system. Before rebooting the system, a
message is displayed.
EXIT STATUS The following exit values are returned:
SEE ALSO rebootxscf(8), showdualpowerfeed(8)
XSCF> setdualpowerfeed -s enable
disable -> enable
NOTE: Dual power feed will be enabled the next time the platform is powered
on.
0 Successful completion.
>0 An error occurred.
To Next Page
Loading...
