setnetwork(8)
System Administration 243
EXTENDED
DESCRIPTION
■ In M8000/M9000 servers, a takeover IP address can be used without a need to
determine whether XSCF has been switched. By setting the LAN ports of the
active XSCF unit as lan#0 and lan#1, they can be accessed with the names
lan#0 and lan#1.
■ In M3000/M4000/M5000 servers, the value of the lan#0 is fixed with xscf#0-
lan#0, and the lan#1 is fixed with xscf#0-lan#1.
interface Specifies the network interface to be configured. One of the
following values can be specified:
■ In M3000/M4000/M5000 servers:
For XSCF unit 0:
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
For abbreviation:
lan#0 an abbreviation of XSCF-LAN#0
lan#1 an abbreviation of XSCF-LAN#1
■ In M8000/M9000 servers:
Specifying the -c or -r option and Inter SCF Network (ISN)
together, it results in errors.
For XSCF unit 0:
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
xscf#0-if ISN
For XSCF unit 1 :
xscf#1-lan#0 XSCF-LAN#0
xscf#1-lan#1 XSCF-LAN#1
xscf#1-if ISN
For takeover IP address:
lan#0 takeover IP address for XSCF-LAN#0
lan#1 takeover IP address for XSCF-LAN#1
To Next Page
Loading...
