setpacketfilters(8)
252 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised April 2010
-i interface Specifies the XSCF network interface to which you set the IP
packet filtering rules. Any of the following can be set.
■ In M3000/M4000/M5000 servers:
For XSCF unit 0:
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
For abbreviation:
lan#0 XSCF-LAN#0
lan#1 XSCF-LAN#1
■ In M8000/M9000 servers:
For XSCF unit 0:
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
For XSCF unit 1:
xscf#1-lan#0 XSCF-LAN#0
xscf#1-lan#1 XSCF-LAN#1
If the -i option is omitted, the default settings are:
■ In M3000/M4000/M5000 servers:
xscf#0-lan#0, xscf#0-lan#1
■ In M8000/M9000 servers:
xscf#0-lan#0, xscf#0-lan#1,
xscf#1-lan#0, xscf#1-lan#1
-j target Specifies action to be taken when the received IP packet
matches the filtering rule, where target is one of the following:
ACCEPT Permits the IP packet to go through
DROP Drops the IP packet
-n Automatically answers "n" (no) to all prompts.
-q Suppresses all messages to stdout, including prompts.
To Next Page
Loading...
