setroute(8)
270 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised April 2010
■ To reflect the routing information to XSCF, execute the applynetwork(8)
command. After reflected the information, use the rebootxscf(8) command to
reset XSCF to complete the setting.
■ The showroute(8) command can display the current routing information that is
set for the XSCF network.
EXAMPLES
EXAMPLE 1 Adds the routing of destination 192.168.1.0 and netmask 255.255.255.0 for
XSCF-LAN#0 on XSCF unit 0.
EXAMPLE 2 Adds the routing of destination 192.168.1.0 and gateway 192.168.1.1 for
XSCF-LAN#1 on XSCF unit 0.
EXAMPLE 3 Adds the routing of destination 192.168.1.0 and default netmask
(255.255.255.0) for XSCF-LAN#1 on XSCF unit 0.
EXAMPLE 4 Deletes the routing of destination 192.168.1.0 and default netmask
(255.255.255.0) from XSCF-LAN#1 on XSCF unit 0.
EXAMPLE 5 Adds the routing of destination 192.168.1. 4 for XSCF-LAN#1 on XSCF unit 0.
EXAMPLE 6 Deletes the routing of destination 192.168.1. 4 from XSCF-LAN#1 on XSCF
unit 0.
EXAMPLE 7 Adds routing information for the default gateway 192.168.10.1 for XSCF-
LAN#1 on XSCF unit 0.
XSCF> setroute -c add -n 192.168.1.0 -m 255.255.255.0 xscf#0-lan#0
XSCF> setroute -c add -n 192.168.1.0 -g 192.168.1.1 xscf#0-lan#1
XSCF> setroute -c add -n 192.168.1.0 xscf#0-lan#1
XSCF> setroute -c del -n 192.168.1.0 -m 255.255.255.0 xscf#0-lan#1
XSCF> setroute -c add -n 192.168.1.4 xscf#0-lan#1
XSCF> setroute -c del -n 192.168.1.4 xscf#0-lan#1
XSCF> setroute -c add -n 0.0.0.0 -g 192.168.10.1 xscf#0-lan#1
To Next Page
Loading...
