console(8)
38 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised September 2008
EXTENDED
DESCRIPTION
■ When the command is executed, a prompt to confirm execution of the command
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
■ The domain console regards "#" used at the beginning of a line as an escape
character. An escape character is specified to instruct the console to perform
special processing. Examples of processing that can be specified in combination
with "#" are as follows.
■ To enter "#" at the beginning of a line, enter "#" twice.
■ To display information on the currently connected domain console, use the
showconsolepath(8) command.
EXIT STATUS The following exit values are returned:
SEE ALSO sendbreak(8), showconsolepath(8)
-r Sets up a connection to a read-only console.
-s escapeChar Specifies an escape character. The default is "#" . The character
specified for escapeChar must be enclosed in "" "" (double
quotation). The following symbols can be specified for escapeChar:
"#", "@", "^", "&", "?", "*", "=", ".", "|"
Specified escape character is available only in the session that
executed the console(8) command.
-y Automatically answers "y" (yes) to all prompts.
"#" and "?" Outputs a status message.
"#" and "." (period) Disconnects the console.
0 Successful completion.
>0 An error occurred.
To Next Page
Loading...
