Prior to shipment, the following inspections and tests are made to ensure the highest standards of
manufacturing for our customers:
•
Material inspections
•
Manufacturing process inspections
•
Hydrostatic test inspection
•
Electrical components inspection
•
Documented Fire and Test (FaT)
•
Packing, inspection and final check
This manual is provided as a guide to the correct operation and maintenance of your Fulton
equipm
ent, and should be read in its entirety and be made permanently available to the staff
responsible for the operation of the boiler. It should not, however, be considered as a complete
code of practice, nor should it replace existing codes or standards which may be applicable.
Fulton reserves the right to change any part of this installation, operation and maintenance
manual.
Installation, start-up,
and maintenance of this equipment can be hazardous and requires trained,
qualified installers and service personnel. Trained personnel are responsible for the installation,
operation, and maintenance of this product, and for the safety assurance of installation, operation,
and maintenance processes. Do not install, operate, service or repair any component of this
equipment unless you are qualified and fully understand all requirements and procedures.
For a specification, refer to Appendix A - VSRT Data Sheets
The VSRT fuel fired steam boiler is a vertical two-pass boiler of efficient design and construction.
The VSRT uses Fulton’s PURE technology to achieve higher efficiency and lower NOx levels with
a smaller footprint than its Fulton J series equivalent.
VSRT connections and specifications are listed in Tables 1 and 2 and shown in Figures 1, 2, 3
and 4.
CONT
INUED ON NEXT PAGE
To Next Page
Loading...
