EGO LOOK
Call setup
Call setup from the EGO LOOK is only possible if there is an existing Bluetooth
®
connection between the EGO LOOK and
the mobile phone. You may set up a call with voice-activated dialing or through the menu.
To activate voice dialing, press the rotary knob for longer than a half a second. With the command „Dial number,“ you can
announce the telephone number to be dialed or with the „Dial <Name>“ command you can dial an entry in the contact list
directly. You can fi nd more information on this in the „Voice control“ chapter. (Take paragraph into account)
The following methods may be used to initiate a call from the menu:
→ by selecting from the contacts list and the mobile phone
→ by direct outward dialing of a number with the number speller
→ dialing from the call list on your mobile phone
→ through the call-back feature for received SMS messages
And lastly, you may also dial a number directly on your mobile phone.
IMPORTANT NOTE: Please observe your country’s regulations on in-car telephone use!
Call ended
Once a call is ended, the menu jumps back to the main menu. If an incoming call is rejected with the key, the menu
jumps to the previous menu.
Setting the volume
You can regulate the volume during a call and during active speech recognition using the rotary knob.
TIP! If the person you‘re speaking with cannot hear you well, consider increasing the sensitivity of the microphone in the
“Audio management” menu under “Settings”. There is a risk, however, that this may produce annoying echoes.
q
q
To Next Page
Loading...
