Furuno FMD3100 - How to Replace the USB Dongle, CFAST Memory Card or SSD; Replacing the CFAST Memory Card; Replacing the USB Dongle; Replacing the SSD

1. MOUNTING
1-7
1.1.5 How to replace the USB dongle, CFAST memory card or SSD
Referring to the table below, prepare the necessary tools to replace the USB dongle,
CFAST memory card or SSD.
Replacing the USB dongle
Replacing the CFAST memory card
Replacing the SSD
Referring to the figure above, remove the SSD case from the SSD slot. Unfasten the
screws cricled in the figure below, then remove the SSD.
Note: When replacing the SSD, only replace the “0” slot drive. Do not replace the “1”
slot drive.
Part Tool Type
USB dongle
Torx screwdriver T10
CFAST memory card
SSD Philips-head screwdriver PH2
To replace the USB
dongle, remove this
USB hatch.
Rear of PSU-3000
To replace the CFAST memory card, remove this cover plate.
SSD slot
LAN2 LAN1
USB2
USB4
USB3
C1
C2
C3
C4
IEC61162-1/2
SSD case