2. WIRING
2-4
2.1.2 Connecting the flush mountable USB Extension Cable
You may require an extension from the USB port on the PCU. A 1m length USB
extension cable is included with the PCU. When using another USB extension cable,
make sure the total length is shorter than 5 m.
You can connect the flush-mounted extension cable by doing the following:
1. Connect the USB extension cable to a USB port on the PCU.
2. Referring to the figure below, make an installation hole where necessary.
3. Unfasten the nut.
4. Insert the cable into the installation hole from the rear.
Cap strap
USB extension cable
LAN2 LAN1
C1
C2
C3
C4
IEC61162-1/2
19.2±0.1
*
ø20.75±0.1
*
Dimensions for installation hole
*
Measurement units are in mm
To Next Page
Loading...
