1. MOUNTING
1-11
1.4 Intelligent Hub HUB-3000 (Optional)
Use the optional Intelligent Hub HUB-3000 to connect gateway network equipment.
This network cannot be connected with the LAN network on board. Note that a
commercial PC cannot be connected to this network, other than for maintenance.
Mounting considerations
Keep the following points in mind when selection a mounting location:
How to mount the intelligent hub HUB-3000
1. Use two binding screws (M3x6, supplied) to attach the cable clamp (supplied) to
the bottom of the HUB-3000.
2. Fasten four self-tapping screws (4x20, supplied) to fix the unit in place.
• Locate the HUB-3000 away from heat sources. The cabinet can build up heat inside,
causing undue wear to electrical components.
• Take into account the length of the cables to connected to the equipment when
choosing an installation location.
• Locate the HUB-3000 away from areas which may be subject to splash or rain.
• Referring to the outline diagrams at the back of this manual, leave sufficient space at
the rear of the HUB-3000 to facilitate maintenance.
• A magnetic compass will be affected if the equipment is placed too close to the
magnetic compass. Observe the compass safe distances at the front of this manual
to prevent interference to a magnetic compass.
• Vibration at the mounting location should be minimum.
HUB-3000, bottom view
Cable clamp
Binding screw
(M3x6, 2 pcs.)
To Next Page
Loading...
