Furuno FMD3100 - Jumper Settings for RCB-002; Jumper Locations on the RA;IF Board (24 P0140)

2. WIRING
2-30
2.4.1 Jumper settings for RCB-002
The RCB-002 is compatible with the following radars.
Change the jumper settings on the RA/IF board (24P0140) according to the radar to
be connected, referring the tables on the next page.
Note: According to the shipment time, the heat dispersion sheet may be attached to
the RA/IF board (24P0140). If the heat dispersion sheet is attached, it may come loose
when removing the RCB-002 cover. Before closing the cover, make sure the disper-
sion sheet is in the location shown below. If the sheet is loose, align it with the locator
lines printed on the board.
Maker Model Maker Model
FURUNO*
• FAR-147 series
• FAR-27 series
• FAR-25 series
• Model 1835
Japan Radio Company
(JRC)
JMA-9100 series
Tokyo Keiki Inc. BR-3440 series
*: FURUNO radars are only compatible with the
CH2 (RADAR SIGNAL IN NO.2 port).
J1 J2
J4
J5 J6
J7
J8
J9
J11
J10
J12
J14
J3
J16
J15
J17
J18
J19
J20
J21
J22
J23
J24 J13
Jumper locations on the RA/IF board (24P0140)
Heat dispersion sheet
Heat dispersion sheet locator lines