Furuno NAVpilot-611 - Adjustments; Accessing the Installation Menu

3-1
3. ADJUSTMENTS
3.1 How to Access the Installation Menu
Set up the equipment through the installation menu. To access the installation menu, do the
followings:
1. Turn the power on at the control unit.
2. Press the STBY key to go to the STBY mode.
3. Press the TURN/MENU key while pressing the STBY key.
4. Release the above keys when the INSTALLATION menu appears.
"DONE" is shown when
setting is completed.
DOCKSIDE SETUP
SEA TRIAL
DISPLAY SETUP
DATA CALIBRATION
MESSAGE
PARAMETER SETUP
SYSTEM SETUP
ALARM SETUP
CONTRAST/BRILLIANCE
ADJUST RUD REF. UNIT: NO
RUDDER TEST: NO
SET CENTER RUDDER POS: NO
AUTO TUNING: NO
COMPASS CALIBRATION: NO
INSTALLATION MENU
Installation menu
Note: The installation should be done in the order in which the items of the installation
menu are listed.