3. ADJUSTMENTS
3-11
3.3 SEA TRIAL Menu
Now it is time to check if your boat can run a set heading straightly with default steering
characteristics, on the open sea. This trial should be conducted in calm water where there is
no boat traffic of obstructions. A sea trial can only be performed when the DOCKSIDE
SETUP menu has been completed and confirmed.
1. Open the INSTALLATION menu.
2. Rotate the course control knob to select “SEA TRIAL”.
3. Press the course control knob to show the SEA TRIAL menu.
COMPASS CALIBRATION*:
MAGNETIC VARIATION:
AUTO
COMPASS OFFSET: E 7.0
AUTO COMP CAL UPDATE**: OFF
SET CENTER RUDDER POSITION
AUTO TUNING: ?
RUDDER DEAD BAND: AUTO
COG: T 359.9 HDG: 359.9
?
*: Appears only when selecting "PG-500"
or "PG-1000" at COMPASS TYPE on the
DOCKSIDE SETUP menu.
**: Appears only when selecting "PG-500" at
COMPASS TYPE on the DOCKSIDE SETUP menu.
***: Heading and course are shown here when
appropriate data are entered.
PUSH MENU KEY TO RETURN***
TO PREVIOUS MENU.
Sea trial menu
To Next Page
Loading...
