48
9.2.2 Hardware: Preparing Your Printer
Clean the bed: If there is residue (priming skirt or old gluestick) on the bed from a previous print, clean it off as
described in section 9.6.
Prep the bed: Apply fresh gluestick to the bed as described in section 9.7. Remember some materials (for example
ABS) get slightly different treatment.
If filament is not already loaded in the printer, load the correct filament as described in section 9.4.
9.2.3 Starting Your Print
There are two ways to start your print:
1) Via the Web Interface
Log onto the web interface and navigate to the “Gcode files” tab. Locate the file you wish to print and click the
green “print” icon next to it.
A confirmation box will pop up. Click “Yes” and the print will start.
To Next Page
Loading...
